Door Installation in Richmond - Free In-Home Measure, Written Price

Fast, Reliable Door Installation Across Richmond

Door installation in Richmond costs $650 to $2,400 for most entry door replacements, with sliding glass door replacements running $1,200 to $3,800 depending on the opening size and frame condition. The bigger variable here is what we find when we open the wall. On pre-1955 Richmond homes, the original steel casement frame flanges are often rusted through at the corners, which means the jamb has to be reframed before any new door goes in. That work adds $250 to $600 to the job, but skipping it guarantees the new door will bind within two seasons. Call (903) 354-7134 for a free estimate, and we’ll give you a written price before any work starts.

Call (903) 354-7134

Why Westlight Windows & Doors Is Richmond’s Preferred Door Installation Company

We’ve been installing doors in Richmond since 2009, and most of what we see is the same story: a 1940s wartime cottage with a door that swells in the fog, sticks at the latch, and never quite closes right. Homeowners tell us they’ve had other contractors out who shaved the door, swapped the weatherstripping, and left. Six months later, the same door is sticking again because nobody addressed what was actually wrong: the steel casement frame underneath had corroded through at the corner welds. We start every Richmond door job by assuming that failure is there until we prove otherwise.

Customers from the Iron Triangle, Shields-Reid, and Point Richmond consistently mention three things in their feedback: we answer the phone when they call, we show up in the window we gave, and the written price we quoted is the price they paid. Richmond’s housing stock is old, and the salt air off the bay punishes cheap hardware fast. That’s why we quote coastal-spec work as our standard here, not as an upgrade. Most single entry door replacements in Richmond run $800 to $1,900 installed, with the final number driven by what we find inside the jamb.

The Door Installation team at Westlight includes Owen Satterfield, who oversees every Richmond job and walks each site himself before we quote. Owen’s been doing this work long enough to know that a door that binds every June is rarely a door problem. It’s a frame problem, or a hinge problem, or a moisture problem, and until you fix the cause, no new door will behave. That’s the difference between a door swap and a door installation done right.

Sliding Glass Door Replacement in Richmond

Sliding glass door replacement in Richmond typically runs $1,200 to $3,800 for a standard 6-foot patio opening, with the price anchored by what’s happening to the track and the frame underneath it. Richmond’s marine fog works its way into aluminum track channels, corroding the rollers and eating the bottom rail until the door grinds instead of glides. By the time most Richmond homeowners call us, the door hasn’t moved smoothly in a year or more.

We carry PGT and CGI sliding door lines specifically because those manufacturers build corrosion-resistant track hardware and reinforced frames that stand up to bay salt exposure. The cheaper inland-spec door with standard rollers will work fine in San Pablo. It will start dragging in Richmond within two or three winters.

Track and Roller Replacement

On a sliding door, the rollers and track are the wear points. Richmond’s salt air eats standard zinc-plated rollers within a few seasons, leaving the door leaning and grinding. We replace the track, rollers, and weatherstripping together so the new door actually slides when you push it.

Full Frame Sliding Door Replacement

If the original 1940s or 1950s framing beneath the sliding door has rotted along the sill, the whole opening needs to be reframed before the new door goes in. We use treated lumber for the new subframe and stainless fasteners throughout, then seal the joints so fog-driven moisture can’t wick back in.

Storm Door Installation in Richmond

Storm door installation in Richmond runs $450 to $1,100 for most standard sizes, and it’s one of the most useful upgrades for older Richmond homes. A good storm door takes the brunt of the wind-driven moisture that comes off the Bay, protecting your main entry door from the fog cycle that rots sills and rusts hinges. On the waterfront end of town in Point Richmond, we consider a storm door nearly mandatory on any exposed west-facing entry.

We install Therma-Tru storm doors with marine-grade hinges and stainless steel hardware because anything less corrodes visibly within a few years here. The standard zinc-plated hinge that lasts a decade in El Sobrante will start to pit and seize in Richmond’s fog belt within three. Owen Satterfield specs the same hardware on a $600 storm door that he’d put on a $2,000 entry door, because the salt air doesn’t care what the door cost.

Full-View Storm Doors

A full-view storm door with a low-e glass insert gives you the light and the protection. In Richmond’s shorter winter days, that light matters, especially on the north-facing entries common in the Iron Triangle’s wartime lots.

Ventilating Storm Doors

When Richmond’s afternoon sun burns off the fog, a ventilating storm door lets you open the glass and run air through the house. The screened panel keeps the door functional through the windy seasons without slamming shut on its own hinges.

Trusted Brands We Service in Richmond

We install doors from PGT, CGI, and Therma-Tru, because those are the three lines we’ve seen hold up longest against Richmond’s specific conditions. PGT and CGI build impact-rated and corrosion-resistant products originally designed for coastal Florida, which translates well to the Bay-facing side of Richmond. Therma-Tru makes the most reliable entry and storm door systems we’ve found for older homes with undersized frames. We keep common Richmond replacement parts in stock locally, which means a hinge, threshold, or weatherstrip order doesn’t leave your door hanging for two weeks while a warehouse in another state processes the shipment.

Common Door Installation Problems We See in Richmond Homes

• Rusted-through steel casement corners. The original 1940s steel casement frames in Iron Triangle cottages corrode completely through at the weld flanges, so the door can no longer be squared or sealed against the jamb. Once that happens, no adjustment or shim will fix the binding door.
• Rotted wood sills and thresholds. Richmond’s fog belt pushes moisture into unsealed wood sills, which delaminate and wick water into the subfloor beneath the door. By the time you see rot from the outside, the framing underneath is usually worse.
• Corroded hinges, strikes, and screws. Standard zinc-plated door hardware pitted and seized within a few years of Bay salt exposure, causing sagging doors and misaligned latches. We specify stainless or marine-grade hardware as our default in Richmond, not as an upsell.
• Undersized wartime door frames. Many 1940s wartime cottages were built with door openings slightly smaller than today’s standard slab sizes. Retrofitting a modern door into one of these openings means reframing the rough opening, not just trimming the door to fit.

Pricing for Door Installation in Richmond, CA

We Also Serve Cities Near Richmond

Beyond our Door Installation in Richmond service area, Westlight Windows & Doors works throughout the neighboring East Bay communities. We regularly install doors in San Pablo, El Cerrito, El Sobrante, and Albany. If you live just outside Richmond and need a door installed or a failing frame replaced, call (903) 354-7134 and we’ll let you know our next available appointment in your area.

FAQs About Door Installation in Richmond